![]() The only thing remaining is to carefully remove the clear backing paper either cold or warm.īut BEFORE you do that, we suggest that you first check the instructions on the HTV you're using to see if the manufacturer advises you to do a Warm or Cold Peel.įor starters, this simply means either removing the line while the material is still warm or letting it cool down. Peel off the backing paper.Īt this point, you have successfully transferred your design onto your item. If you make the MISTAKE of moving your iron around, your HTV might start shifting and moving in the undesired locations…not to forget it'll not correctly adhere to the item you're transferring to. You want to apply heat and pressure, just like what the heat press machine does. IMPORTANT: The idea here is to apply pressure (i.e., place the iron on your design and hold), not to move it around. If you're working on a larger design than the iron surface, you'd want to press it, one section at a time, until the entire design gets pressed down. Be sure to apply the pressure for about 10-15 seconds. If you want, you can start with light pressure and increase to firm pressure. Once the iron is hot and ready for use, put in on your design, and exert firm pressure. Power ON your iron and set it to high/cotton. Once you have placed the design in place and aligned it correctly, cover it with a thin towel or Teflon sheet (whichever you prefer) and move on to the next step. Make sure the clear backing side is up onto the side of the t-shirt where you plan to imprint the design. Now grab your HTV design and place right on your t-shirt, where you want it to appear after it's transferred. The reason why you'd want to pre-heat your tee is to help eliminate any wrinkles present and to eliminate any moisture that can make the HTV fail to stick firmly to your t-shirt fabric. Make sure you do the same for the back side of the tee as well.Īlso Read: Best Microsoft Office Alternatives 2023 Pass the iron over it for around 10-15 seconds to warm it. Next, you'll need to prepare the area of your t-shirt where you'll be aping your design by pre-heating it. Preheat the t-shirt area where you'll be applying the design Remember that your design should look backward o the HTV because you mirrored it during the cutting process. In the end, you want to be left with your design only at the clear backing of your HTV. Then, you can weed it to remove excess vinyl that you don't want to appear in your final design. The first step is pretty obvious as it involves cutting your design with the help of a vinyl cutter. ![]() Steps for applying HTV with Iron Heat-Transfer-Vinyl-With-An-Iron Step 1.
0 Comments
Leave a Reply. |